Key Fire Hose - FLAME OUT MSHA Double Jacket

FLAME OUT MSHA Double Jacket

Vendor: Key Fire Hose

Category: Fire Protection


Application:

Key Fire "Flame Out" MSHA approved double jacket fire hose

  • 800 Pound Test Heavy Duty Lightweight
  • MSHA approved
  • Extruded Tube File #18-FHA080002
  • 1-1/2" & 2"
  • 1 year warranty
  • Abrasion Resistance
  • Cold Resistance
  • Heat Resistance
  • Self Extinguishing
  • Flame Resistant

PROUDLY MADE IN THE USA

Quality:

The fire hose assembly supplied under this specification shall be constructed with superior quality materials. NFPA 1961 standards shall be observed in production of the assembly, in order to ensure its quality and durability. Hose furnished under these specifications will have a potential service life warranty of one year; barring mistreatment that would render it unfit for service. Upon delivery, the hose shall be free from defects in workmanship and materials. Any defective hose will be replaced at no charge.

Jacket Construction

The double jackets will be woven evenly and be free of defects, including knots lumps or unsightly disfigurations that could jeopardize the integrity of the hose assembly. The warp yarn shall consist of staple polyester yarn. The use of filament or entangled yarn is expressly forbidden due to the lack of inherent abrasion resistance. The filler yarns shall be constructed of high strength, low elongation, filament polyester to reduce weight and increase flexibility.

Lining

The lining shall be a single-ply extruded tube of synthetic polyurethane based material to resist ozone. This special MSHA approved material shall adhere to the jacket by vulcanization process to prevent delamination and/or hydrolysis. The finished product will meet and exceed all MSHA specifications and be listed with File #18-FHA080002. This product is designed with self-extinguishing characteristics meeting MSHA standards.Neoprene or other rubber products that give off chlorine or other toxic gases shall not be acceptable.

Hydrostatic UL Testing

Service test pressure shall pass 400 PSI. Acceptance test pressure shall pass 800 PSI. Curve and straight burst testing shall pass 1200 PSI. All testing shall be in accordance with NFPA 1962 and UL-19 procedures.

Finished Hose

Printed letters with the words "“Flame-resistant USMSHA 18-FHA080001" must be permanently marked on the product with letters at least 1/4" high and at intervals not exceeding 3 feet. NFPA approved markings shall be stenciled 4 feet from each end.

Couplings

Internal expansion ring threaded couplings or as required by purchaser. Please contact your JGB Sales Representative.

** Customers are advised special diameters or construction characteristics may be produced
by special request. For more information please contact your JGB Sales Representative.

Weights & Measures

Size Part No. Service Test Proof Test Burst Test Bowl Size Weight/50ft. Request Quote
1 1/2" DP15-MSHA 400 psi 800 psi 1200 psi 1 15/16" 19 lbs. Request Quote
2" DP20-MSHA 400 psi 800 psi 1200 psi 2 7/6" 23 lbs. Request Quote
2 1/2" DP25-MSHA 400 psi 800 psi 1200 psi 3" 32 lbs. Request Quote
   WARNING: Cancer and
   Reproductive Harm -
   www.P65Warnings.ca.gov