Valve Selection Guide

Ball Valve

• Can be used for on and off service or throttling
• When positive shut-off is necessary
• Where a low valve profile is necessary
• Only 90° rotation from open to fully closed (quick opening)
• Handle position is a quick indication of whether valve is
  open or closed
• Full port ball valves do not resist flow

Butterfly Valve

• Where positive shut-off is necessary
• Primarily for fully open or fully closed applications
• May be used for throttling
• Only 90° rotation from open to fully closed
• Lightweight
• Easy to install
• Less costly than an iron body gate valve

Gate Valve

• For fully open or fully closed service - not for throttling
• For minimum line pressure drop
• For minimum fluid entrapment in the line
• For relatively infrequent operation

Check Valve

• To control the direction of flow and for quick, automatic reactions to flow change. Swing check valves are used when a minimum resistance to flow is required.
• Swing check valves are recommended for use in conjunction with gate valves. They should not be used in a rapid recycling system such as reciprocating pumps or air compressor service where they could cause chatter and damaging vibration.

Globe Valve

• For regulation (throttling) of flow
• For frequent operation; short stem travel reduces operator's time
• Where some line resistance is acceptable